点火电路
- Electronic firing energy is dissipation by improving leakage circuit when the fuze is dud.
改进泄漏电路，对电发火能量彻底耗散。 - To avoid the affect of sneak circuit to firing control circuit of aviation weapon, a sneak circuit analysis is performed to a certain missile control system.
为排除潜电路对航空武器发射的影响，以某型号飞机和某型号导弹发射架控制电路为例，对该型号导弹发射控制电路的潜电路进行了分析。 - The complete system simulation of the DTC including induction motor, inverter switch, firing circuit and control unit is done using the MATLAB/ MULINK program.
利用MATLAB/MULINK软件做的直接力矩控制的仿真系统包括感应电动机、逆变器开关、触发电路和控制电路。 - Design and Reliability Analysis of Blasting Firing Circuit for a 17-storeyed High Building in Hefei
合肥17层高楼爆破网路设计及可靠度分析 - The demolition method, selection of blasting parameters, layout of firing circuit and blasting effectiveness of bi directionally toppling a building are discussed, also, the reliability of controlling the toppling direction, initiation sequence and height of burst are investigated.
本文论述了楼房双向定向爆破的拆除方法，爆破参数的选取，爆破网路的敷设和爆破效果，阐明了炸高与起爆顺序控制倒塌方向的可靠性。 - The cassette of firing control circuit is made and that is proved correct through the electric firing test.
设计制作了射击控制装置，并进行了电子发火试验，成功实现了对电子点火头的顺序发火。 - Design of Digital Firing Circuit Based on CPLD
基于CPLD的数字触发电路的设计 - According to the generating theory of SHEPWM wave, a design of digital firing circuit on SHEPWM based on CPLD is implemented and correctness of design is verified by practical experiment.
根据SHEP-WM波形发生原理，设计和实现一种基于CPLD的SHEPWM数字触发电路。通过实际的现场实验，验证设计的正确性。 - A new series-parallel-series firing circuit is designed, and a reliability formula of the electric and non-electric circuit is presented.
设计了一种新的串-并-串联爆破网路，提出了电-非电网路可靠性计算公式。 - The part about firing pacing pulses introduces the brief development history of pacemaker, the circuit principle of pacing hardware, the implementation of pacing arithmetic and test verification of pacemaker. This part also states that the EMC of the module has been improved.
在脉冲发放部分主要阐述了起搏器的发展简史、起搏硬件电路原理、起搏算法实现和起搏的测试验证，同时也阐述了本模块EMC性能的提高。 - It is also demonstrated that there are several factors causing HVDC converter commutation failure, the most important factors include the advance firing angle, the voltage drop of the converter AC bus, the direct current increment and the short circuit impedance of the converter transformer.
论证了影响逆变器换相失败的因素有多个，重点研究了触发越前角、换流站交流母线电压跌落，直流电流增大以及换流变压器短路阻抗等因素对换相失败的影响。 - The digital display principle of firing angle about mechanical aiming equipment of artillery is studied, and the circuit of digital display is emphasized.
对地面火炮所装备的机械瞄准具射角电子数字显示的原理进行了研究，重点对电子数字显示电路进行了介绍。 - The measuring circuit of the current sensor isolated measuring method is completely isolated from firing circuit, thus the measuring accuracy and test reliability can be improved.
电流传感器隔离测量方法中测量电路完全与点火电路隔离，提高了测量的准确性，增强了点火试验的可靠性。 - Design of Blasting Firing Circuit for Demolishing Special Brick-concrete Building
特殊砖混结构楼房爆破拆除起爆网路设计 - Single chip microcomputer-controlled firing circuit of thyristor converter
单片机控制的晶闸管脉冲触发电路 - Submitting and Analysis of the Firing Value Formula in the Electric Blasting Series Circuit
电爆网络串联准爆公式的提出和分析 - This paper gives the analysis on the firing error caused by the gun oscillation, and proposes a better compensation algorithm and circuit implementation.
分析了由火炮摆动带来的射击误差，给出了相应的补偿算法及电路的实现方法。 - This paper introduces a new circuit using the zero-voltage-switched ( ZVS) technology for simmering Xe Lamp. The firing voltage and the simmering current are supplied by different circuit separately.
本文提出了在脉冲氙灯预燃电路中将着火电压与预燃电流由不同电路来提供的设计思路，并采用了零电压开关技术。